houstongaragedoorspecialists.com :: Steps to Program a Homelink Garage Door Opener Using Rolling Codes - Garage Door Repair Blogs
Tap to Call Now!
Tap to Call Now!     (713)491-6999    (281)606-0120    (832)678-8804
Today's Offer - $75 Off Any Garage Door Repair

Save Big with Exclusive Special Offers!

99
199
249
125
75
100
Half Price
200
99.95
89
149
Today's Offer - $75 Off Any Garage Door Repair

Posted on 2016-12-21 by Author admin

Are you having problem programming your Homelink garage door opener that has rolling codes? Well, do not worry, follow the steps in your car to program the Homelink system to turn on your garage door. Each car; however, has different features, but these steps will be workable on most cars.

  • Readjust the homelink system in your car by hitting the first and third buttons of the garage door opener till the status light flashes.
  • Now, hit the button to program
  • You can notice that the button starts flashing slowly
  • Now keep the hand-held garage door opener about ten inches away from the sensor in the car. Keeping the sensor a few inches above the license plate is also an option. Press the button and hold it till the brake lights flash for three times.

If your garage door is equipped with the rolling codes, you can follow the next set of steps.

How to Reset the Rolling Codes on the Garage Door Opener

Rolling codes are a security code that is found in memory of the remote device and the opener of the garage door. When you push the button of the remote control, a security code is sent commanding to open and close the garage door. When the codes match, the garage door opener follows the command.

  • Move your car outside of your garage door
  • Now take off the plastic covering around the garage door mechanisms light
  • A garage door opener has a Learn Now button on it
  • Hit the Learn Now button on your garage door opener
  • You need to press the garage door opener in your car for thirty seconds
  • Hold on the button until the light on the garage door opener blinks
  • Release the button and press it again
  • Now the garage opener in your is programmed and ready to operate your garage door.

If you are having trouble programming your Homelink garage door opener even after following these steps, you can call Houston Garage Door Specialists. We are here to help you in every step of programming the opener. Call our helpline number if you need any assistance related to your garage door.

We Service and Repair All Brands of Doors and Openers

allstar amarr chamberlain chi safe-way craftsman delden digi-code doorlink genie guardian haas-door liftmaster
linear marantec mid-america moore-o-matic multi-code northwest raynor safe-way sears skylink stanley udt wayne-dalton

Contact Info

San Felipe Plaza, 5847 San Felipe, 17th Floor
Houston , TX 77057

Call Now! (713)491-6999  (281)606-0120  (832)678-8804